Switch off ignition and disconnect a "weight" wire from the storage battery.
PREVENTION
Chalk, marker or paint note the direction of rotation of a poliklinovy belt. If at installation poliklinovy the belt rotates in other party, it can lead to its destruction.
|
Release cars till 2001
Weaken a tension and remove a belt from pulleys, since a pulley of a cranked shaft. At replacement of a belt of a drive of the pump of the amplifier of a steering previously it is required to remove a belt of a drive of the compressor of the conditioner.
|
Fig. 2.15. An arrangement of a poliklinovy belt on engine pulleys: And — it is correct; In — it is wrong
|
After replacement of a belt check that the belt is correctly located on engine pulleys
(fig. 2.15)
.
Adjust a belt tension.
Release cars since 2001
|
Fig. 2.16. Weakening of a tension of a poliklinovy belt on cars since 2001: 1–shestigrannik of the mechanism of a tension
|
Establish a cap key on a shestigrannik of the mechanism of a tension, turn it clockwise for weakening of a tension of a belt, and remove a belt from pulleys
(fig. 2.16)
. Slowly release the mechanism of a tension of a belt.
Again a key turn the tension mechanism clockwise and establish a new belt on engine pulleys, then smoothly release the tension mechanism.
Check that the belt is correctly located on engine pulleys
(fig. 2.15)
.
Connect a "weight" wire to the storage battery.