Use only fresh brake DOT 4 liquid.
Uncover a tank with brake liquid.
Syringe pump out brake liquid from a tank.
Fill a tank with fresh brake liquid to exclude air hit in brake system from a tank. Watch that level of brake liquid was in a tank not below MIN mark during carrying out procedure.
Replacement of brake liquid make for each branch hydraulic a kennel in the same sequence, as air removal.
Remove a dustproof cap from the union of pumping of a forward left support, clear it and put on it one end of a pure transparent hose, other its end lower in the capacity which has been partially filled with brake liquid. The capacity should be not less than on 300 mm above the pumping union. Thanks to it air hit in a support through a carving of the union of pumping is prevented.
Sharply press a pedal of a brake of 3-5 times with an interval 2–3 with, turn out on a half of turn the pumping union at the pressed pedal. Continuing to press a pedal, force out the old brake liquid which was in a contour through a hose in capacity. After the pedal will reach extreme bottom situation and the liquid effluence through a hose will stop, wrap the pumping union to the full. Release a brake pedal that she returned to a starting position.
Repeat these operations while the union of pumping will not leave fresh brake liquid.
PREVENTION
During operations on replacement of brake liquid watch level of brake liquid in a tank.
|
Holding a pedal in the pressed situation, wrap the pumping union against the stop and remove a hose.
Wipe the union of pumping and establish a protective cap.
NOTE
Recommended periodicity: each 50 000 km of run or 24 months.
|
NOTE
On cars, since 2001, the fuel filter is an integral part of the block of the fuel pump established in a fuel tank. Its periodic replacement is not provided.
|
Repeat these operations for hydraulic contours of other wheels.