RAV4 PAB4-Toyota Toyota
1. Car operation
2. Maintenance
3. Engines
4. Cooling and conditioning systems
5. Fuel system and system of production of the fulfilled gases
6. Ignition system
7. The monitoring system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of a drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
   General information
   Technical characteristics
   Electric chains
   Check of the storage battery
   Replacement of wires of the storage battery
   Safety locks and relay
   Check and replacement of the relay of indexes of turn and alarm light system
   Check of system of a charging
   Generator
   System of start-up of the engine
   Replacement of the combined podrulevy switches
   Replacement of the lock and cylinder of the lock of ignition
   Removal and installation of switches of the dashboard
   Removal and installation of a combination of devices
   Check and replacement of the engine of a screen wiper
   Radio receiver and loudspeakers
   Aerial replacement
      Aerial removal
      Aerial installation
   Check and repair of a heater of back glass
   Replacement of lamps in headlights
   Adjustment of light of headlights
   Headlight replacement
   Sound signal
   Replacement of filament lamps
   Check of a drive of external rear-view mirrors
   System check cruise control
   Check of window regulators with an electric drive
   Check of system of the central blocking of locks
   Drive of the elevating and movable panel of a roof
   Safety cushions
Electric equipment schemes






Toyota RAV4>> Electric equipment>> Aerial replacement>> Aerial installation
Installation of the aerial make as follows.
On cars with the aerial established on a roof, establish the aerial and fix screws.
On cars with the aerial established on a wing, establish on it the holder of the aerial and fix it a bolt, then establish an aerial core in the holder.
Installation of the automatic aerial make as follows:
Establish the aerial under an arch of a wheel and fix a bolt.

Fig. 15.43. At installation of a core of the automatic aerial teeths of a cable of the aerial should be directed to a forward part of the car


Establish an aerial core in the holder of the aerial so that teeths of a cable were directed to a forward part of the car (fig. 15.43) .
Turn a key in the ignition lock in the situation LOCK, thus the aerial should fall in the holder of the aerial.
Establish the basis of the aerial and fix it a nut.
Further installation of aerials of all types make as follows:
Carry out an aerial wire behind a ware box to a radio receiver.
Establish a radio receiver.
Establish a ware box.