RAV4 PAB4-Toyota Toyota
1. Car operation
2. Maintenance
3. Engines
4. Cooling and conditioning systems
5. Fuel system and system of production of the fulfilled gases
6. Ignition system
7. The monitoring system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of a drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
   General information
   Technical characteristics
   Electric chains
   Check of the storage battery
   Replacement of wires of the storage battery
   Safety locks and relay
   Check and replacement of the relay of indexes of turn and alarm light system
   Check of system of a charging
   Generator
   System of start-up of the engine
   Replacement of the combined podrulevy switches
   Replacement of the lock and cylinder of the lock of ignition
   Removal and installation of switches of the dashboard
   Removal and installation of a combination of devices
   Check and replacement of the engine of a screen wiper
   Radio receiver and loudspeakers
   Aerial replacement
   Check and repair of a heater of back glass
   Replacement of lamps in headlights
   Adjustment of light of headlights
   Headlight replacement
   Sound signal
   Replacement of filament lamps
   Check of a drive of external rear-view mirrors
   System check cruise control
   Check of window regulators with an electric drive
   Check of system of the central blocking of locks
   Drive of the elevating and movable panel of a roof
   Safety cushions
Electric equipment schemes




Toyota RAV4>> Electric equipment>> Replacement of lamps in headlights
       PREVENTIONS
H7 filament lamps of an elevated pressure can burst at replacement therefore it is necessary to replace these lamps in gloves and goggles.
Do not concern a glass flask of a lamp barehanded. Fatty traces on a lamp lead to dimness of a flask and a fast exit of a lamp out of operation. Surely replace the failed lamps with lamps of the same type. Fatty spots arising on imprudence wipe a pure bezvorsovy rag or alcohol.

Replacement of lamps make as follows:
Open a cowl.
From a reverse side of a headlight disconnect the electric socket, previously having released a clamp.

Fig. 15.47. Removal of a rubber protective cover from a headlight


Pull back a rubber protective cover and remove it from a headlight (fig. 15.47) .
Turn a cartridge with a lamp counter-clockwise and remove it from a headlight.
Having pulled, take a lama from the boss.
Insert a cartridge with a lamp into a headlight and turn it clockwise.
Establish a rubber protective cover and connect the electric socket.