RAV4 PAB4-Toyota Toyota
1. Car operation
2. Maintenance
3. Engines
4. Cooling and conditioning systems
5. Fuel system and system of production of the fulfilled gases
6. Ignition system
7. The monitoring system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of a drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
   General information
   Technical characteristics
   Electric chains
   Check of the storage battery
   Replacement of wires of the storage battery
   Safety locks and relay
   Check and replacement of the relay of indexes of turn and alarm light system
   Check of system of a charging
   Generator
   System of start-up of the engine
   Replacement of the combined podrulevy switches
   Replacement of the lock and cylinder of the lock of ignition
   Removal and installation of switches of the dashboard
   Removal and installation of a combination of devices
   Check and replacement of the engine of a screen wiper
   Radio receiver and loudspeakers
   Aerial replacement
   Check and repair of a heater of back glass
   Replacement of lamps in headlights
   Adjustment of light of headlights
   Headlight replacement
   Sound signal
   Replacement of filament lamps
   Check of a drive of external rear-view mirrors
   System check cruise control
   Check of window regulators with an electric drive
   Check of system of the central blocking of locks
   Drive of the elevating and movable panel of a roof
   Safety cushions
Electric equipment schemes


Soap 2 day




Toyota RAV4>> Electric equipment>> Replacement of the lock and cylinder of the lock of ignition
       PREVENTION
Cars are equipped with the systems of safety (SRS) including safety cushions and natyazhitel of seat belts. Before work about sensors of blow, the dashboard and a steering column disconnect at first negative, and then positive the plug from the storage battery and wait for 2 minutes. It will exclude unauthorized disclosure of safety cushions and operation of natyazhitel of seat belts which can put injuries.

Replacement of the lock and the cylinder of the lock of ignition make as follows:
Switch off ignition and disconnect a "weight" wire from the storage battery.
Insert a key into the lock of ignition and turn it in the situation ACC.
Remove a steering wheel.
Remove casings of a steering column.
Remove the combined podrulevy switches.
Disconnect from the ignition lock the electric socket.

Fig. 15.22. An arrangement of screws of fastening of the lock of ignition to a steering column


Turn out screws and remove the ignition lock together with the lock cylinder (fig. 15.22) .

Fig. 15.23. Extraction of the cylinder of the lock of ignition after key installation in situation ASS and clamp pressing


Small screw-driver press a clamp in the case of the lock of ignition and for a key take the cylinder of the lock of ignition (fig. 15.23) .
For installation of the cylinder of the lock of ignition, press a clamp and in this provision of a clamp, insert the lock cylinder into the case of the lock of ignition, thus a clamp should enter into an opening and fix the cylinder in the case of the lock of ignition.
Further installation make in sequence, return to removal.