Removal of the aerial make as follows.

Fig. 15.39. An arrangement of screws of fastening of the aerial established on a roof

For removal of the aerial established on a roof, turn out 2 screws and separate the aerial from a body (fig. 15.39) .

Fig. 15.40. A reversing of a core of the aerial established on a wing of the car

Fig. 15.41. A reversing of a nut of fastening of the basis of the aerial established on a wing of the car

For removal of the aerial established on a forward wing, turn out an aerial core, then turn out a nut of fastening of the holder of the aerial and separate it from a body (fig. 15.40, 15.41) .

Removal of the automatic aerial make as follows:

Turn a key in the ignition lock in the situation "LOCK" and weaken nuts of fastening of the aerial.

Turn a key in the ignition lock in the situation "ACC" and press the button of inclusion of a radio receiver in AM range, thus the aerial will automatically be put forward before situation at which it will be disconnected from the drive mechanism.

Separate an aerial core from the holder.

Further removal of aerials of all types make as follows.

On cars with the aerial established on a wing, lift the car on the lift and remove a forward wheel.

On cars with the aerial established on a roof, for access to a wire of the aerial remove an upholstery of a forward rack.

Fig. 15.42. An arrangement of a bolt of fastening of the aerial established on a wing of the car

On cars with the aerial established on a wing, from under an arch of a wheel turn out a bolt of fastening of the holder of the aerial (fig. 15.42) .

On cars with the aerial established on a wing, put forward aerial fastening in a wing and remove condensing ring.

Remove a radio receiver and disconnect from it the aerial tip.

On cars with the aerial established on a wing, remove a ware box and extend an aerial wire.

On cars with the automatic aerial disconnect the basis of the aerial and an aerial wire from a gear cable of the engine.