RAV4 PAB4-Toyota Toyota
1. Car operation
2. Maintenance
3. Engines
4. Cooling and conditioning systems
5. Fuel system and system of production of the fulfilled gases
6. Ignition system
7. The monitoring system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of a drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
   General information
   Technical characteristics
   Electric chains
   Check of the storage battery
   Replacement of wires of the storage battery
   Safety locks and relay
   Check and replacement of the relay of indexes of turn and alarm light system
   Check of system of a charging
   Generator
   System of start-up of the engine
   Replacement of the combined podrulevy switches
   Replacement of the lock and cylinder of the lock of ignition
   Removal and installation of switches of the dashboard
   Removal and installation of a combination of devices
   Check and replacement of the engine of a screen wiper
   Radio receiver and loudspeakers
      Removal and radio receiver installation
      Removal and installation of broadband loudspeakers
      Removal and installation of high-frequency loudspeakers
   Aerial replacement
   Check and repair of a heater of back glass
   Replacement of lamps in headlights
   Adjustment of light of headlights
   Headlight replacement
   Sound signal
   Replacement of filament lamps
   Check of a drive of external rear-view mirrors
   System check cruise control
   Check of window regulators with an electric drive
   Check of system of the central blocking of locks
   Drive of the elevating and movable panel of a roof
   Safety cushions
Electric equipment schemes






Toyota RAV4>> Electric equipment>> Radio receiver and loudspeakers>> Removal and radio receiver installation
Removal of a radio receiver make as follows.
Switch off ignition and disconnect a "weight" wire from the storage battery.

Fig. 15.35. An arrangement of screws of fastening of furnish of a radio receiver on models till 2001


On models till 2001 turn out screws and remove the panel of furnish of a radio receiver (fig. 15.35) .
On models since 2001 remove the central overlay of the dashboard.

Fig. 15.36. Arrangement of screws of fastening of a radio receiver


Turn out screws and extend a radio receiver for access to electric sockets and the aerial tip, located from a reverse side of a radio receiver (fig. 15.36) . Disconnect electric sockets and the aerial tip, and remove a radio receiver from the car.
Installation of a radio receiver make in sequence, return to removal.