Removal of the switch of the alarm light system on models till 2001 make as follows:

Fig. 15.24. Screw-driver use for separation from the dashboard of the switch of the alarm light system

Using a screw-driver edge as the lever, separate the switch of the alarm light system and take it from the dashboard (fig. 15.24) .

Disconnect the electric socket, wring out a clamp and take the switch from a casing.

Switch removal

alarm light system

on models since 2001

It is made as follows.

Fig. 14.51. An arrangement of screws of fastening of the central overlay of the dashboard on models since 2001

Turn out screws and remove the central slip from the dashboard (see fig. 14.51 ).

Fig. 15.25. Arrangement of screws of fastening of the control unit heater

Turn out screws and extend from the dashboard the control unit a heater, then disconnect the electric socket from a back part of the switch (fig. 15.25) . Wring out a clamp and take the switch from a casing.

Installation of the switch of the alarm light system make in sequence, return to removal.