RAV4 PAB4-Toyota Toyota
1. Car operation
2. Maintenance
3. Engines
4. Cooling and conditioning systems
5. Fuel system and system of production of the fulfilled gases
6. Ignition system
7. The monitoring system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of a drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
   General information
   Technical characteristics
   Electric chains
      Detection of damages to a chain
      Electric sockets
   Check of the storage battery
   Replacement of wires of the storage battery
   Safety locks and relay
   Check and replacement of the relay of indexes of turn and alarm light system
   Check of system of a charging
   Generator
   System of start-up of the engine
   Replacement of the combined podrulevy switches
   Replacement of the lock and cylinder of the lock of ignition
   Removal and installation of switches of the dashboard
   Removal and installation of a combination of devices
   Check and replacement of the engine of a screen wiper
   Radio receiver and loudspeakers
   Aerial replacement
   Check and repair of a heater of back glass
   Replacement of lamps in headlights
   Adjustment of light of headlights
   Headlight replacement
   Sound signal
   Replacement of filament lamps
   Check of a drive of external rear-view mirrors
   System check cruise control
   Check of window regulators with an electric drive
   Check of system of the central blocking of locks
   Drive of the elevating and movable panel of a roof
   Safety cushions
Electric equipment schemes






Toyota RAV4>> Electric equipment>> Electric chains>> Electric sockets
The majority of connections in an electric network of the car is executed by multicontact sockets in the plastic case. Sections (half) of sockets after connection usually are kept by the clamps cast in the case of the socket.
Sections of big sockets, for example, established under the dashboard, incorporate together the screw passing through the center of the socket.
To disconnect the socket with a clamp, a small screw-driver wring out a clamp (ы), then disconnect demanded section of the socket. Attentively examine the socket as often clamps of sockets are imperceptible at first sight. Many sockets have on нескольку clamps.

       PREVENTION
At separation of the socket do not pull socket section in different directions for wires as it is possible to damage or pull out wires from clips of contacts of the socket.