Removal of the external handle and the cylinder of the lock of a door make as follows:
Lift against the stop door glass, then remove an upholstery and a pylevlagozashchitny film from a door.
Not to scratch a paint and varnish covering of a door, paste on a door about the handle a sticky tape.
Through an opening in the internal panel of a door release plastic clips and disconnect drafts from the external handle of a door and the lock cylinder.
On models till 2001 further operate as follows:
– turn out bolts of fastening of the handle and remove from a door the external handle together with the lock cylinder;
– remove a clip and take the lock cylinder from the handle.
On models since 2001 operate as follows:
|
|
Fig. 14.31. Removal of a cap from a door end face for access to the screw of fastening of the cylinder of the lock of a door on models since 2001
|
|
|
Fig. 14.32. Removal of the cylinder of the lock from a door on models since 2001
|
– remove a cap from a door end face, turn out the screw of fastening and remove the lock cylinder from a door
(fig. 14.31, 14.32)
;
|
|
Fig. 14.33. An arrangement of bolts of fastening of the external handle to a door on models since 2001
|
– from the interior of a door turn out a bolt and remove the external handle from a door
(fig. 14.33)
.
Installation make in sequence, return to removal.