PREVENTION
Cars are equipped with the systems of safety (SRS) including safety cushions and natyazhitel of seat belts. Before work about sensors of blow, the dashboard and a steering column disconnect at first negative, and then positive the plug from the storage battery and wait for 2 minutes. It will exclude unauthorized disclosure of safety cushions and operation of natyazhitel of seat belts which can put injuries.
|
Removal of forward wings make in a sledushchy way:
Tighten the parking brake and block back wheels an emphasis.
Weaken nuts of fastening of a forward wheel.
Lift a forward part of the car and establish on support.
Remove a forward wheel.
Open a cowl.
On models till 2001 remove the panel located under a headlight.
On models since 2001 remove a front grille.
Remove a front bumper (see above).
Remove a headlight.
|
Fig. 14.12. An arrangement of clamps and screws (the bottom clamps are not shown) fastenings of an antisplash guard of an arch of a forward wheel
|
Release clamps, turn out screws and remove an antisplash guard of an arch of a forward wheel
(fig. 14.12)
.
If the right wing acts in film, remove the radio receiver aerial. At removal of the left wing remove a rack of support of a cowl in open situation.
Open a forward door and turn out the top bolt of fastening of a wing to a car body.
Turn out the bottom bolt of fastening of a wing to a car body.
|
Fig. 14.13. An arrangement of a bolt of fastening of the wing, an available wheel from under an arch
|
Turn out a bolt of fastening of the wing, available from under a wheel arch
(fig. 14.13)
.
|
Fig. 14.14. Arrangement of a bolt of fastening of a forward part of a wing
|
Turn out a bolt of fastening of a forward part of a wing
(fig. 14.14)
.
|
Fig. 14.15. Arrangement of bolts of fastening of the top part of a forward wing
|
Turn out 3 bolts of fastening of the top part of a forward wing
(fig. 14.15)
.
Remove a wing from the car, thus be careful not to scratch the panels of a body close to a wing.
Installation make in sequence, return to removal, taking into account the following:
Establish a forward wing on the car, combine openings under screws and clamps and fix it.
At installation of a wing check, that gaps between a wing and a cowl, and also between a wing and a forward door were uniform on all length.