Removal and installation of a door carry out surely with the assistant as follows:
Lift against the stop door glass.
Switch off ignition and disconnect a "weight" wire from the storage battery.
Open a door and support it supports or jacks, having laid between them and a door pure rags.
Remove an upholstery and a pylevlagozashchitny film from a door.
Mark and disconnect from a door all electric sockets, clips of fastening of wires and a wire of connection with "weight".
Disconnect from a door the protective goffered cover and through the opened opening extend wires from a door.
|
|
Fig. 14.25. Arrangement of bolts of fastening of the limiter of opening of a door
|
Turn out bolts of fastening of the limiter of opening of a door
(fig. 14.25)
.
Marker note position of hinges of a door.
|
|
Fig. 14.26. An arrangement of bolts of fastening of the bottom hinge of a forward door to a door (fastening of the top hinge similar)
|
|
|
Fig. 14.27. An arrangement of bolts of fastening of hinges of a back door to a door
|
While the assistant supports a door, turn out bolts of fastening of hinges to a door and remove a door from the car
(fig. 14.26, 14.27)
.
For access to bolts of fastening of hinges of a back door open a forward door.
Installation of a door make in sequence, return to removal, taking into account the following:
Fix a pylevlagozashchitny film, having established it without folds and gaps. The surface on which the pylevlagozashchitny film is pasted, should be ideally pure.