RAV4 PAB4-Toyota Toyota
1. Car operation
2. Maintenance
3. Engines
   Engine 3S-FE repair without its removal from the car
      General information
      Specifications
      Installation of the piston of the first cylinder in the top dead point (VMT)
      Cover of a head of the block of cylinders
      Inlet collector
      Final collector
      Gear belt and pulleys of a gear belt
      Forward sealing ring of a cranked shaft
      Sealing ring of a camshaft
      Camshafts and pushers of valves
      Head of the block of cylinders
      Oil pallet
      Oil pump
      Drive flywheel / plate
      Back sealing ring of a cranked shaft
      Support of the power unit
   Engine 1AZ-FE repair without its removal from the car
   Diagnostics and preparation of the engine for major maintenance
4. Cooling and conditioning systems
5. Fuel system and system of production of the fulfilled gases
6. Ignition system
7. The monitoring system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of a drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
Electric equipment schemes






Toyota RAV4>> Engines>> Engine 3S-FE repair without its removal from the car>> General information
This section is devoted to repair of the engine 3S-FE established in a motor compartment. The engine was established on cars till 2001.
Before work on the engine, clear a motor compartment and the engine fat-free means. It considerably will facilitate performance of any works.
For improvement of access to the engine it is desirable to remove a cowl. Capes protect wings to prevent damage of a paint and varnish covering.
On the engine established in the car, it is possible to adjust, remove, check, replace and to establish the following details, knots and units:
– inlet and final collectors;
– laying of inlet and final collectors;
– oil pallet;
– laying of the oil pallet;
– sealing rings of a cranked shaft;
– head of the block of cylinders;
– laying of a head of the block of cylinders;
– oil pump;
– starter;
– generator;
– knots of fuel system;
– camshafts;
– to adjust gaps of valves;
– poliklinovy belts of a drive of hinged units;
– gear belt;
– pulleys;
– support of the power unit;
– drive flywheel/plate.