RAV4 PAB4-Toyota Toyota
1. Car operation
2. Maintenance
3. Engines
4. Cooling and conditioning systems
   General information
   Specifications
   Service and repair of system of cooling
      Thermostat
      Radiator fan
      Radiator and broad tank
      Water pump
      The sensor of the index of temperature of cooling liquid
      Thermoswitch of the fan of a radiator
      Electric motor of the fan of a heater
      Knot of management of heating and air conditioning systems
      Heater radiator
   Check and service of central air of air
5. Fuel system and system of production of the fulfilled gases
6. Ignition system
7. The monitoring system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of a drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
Electric equipment schemes






Toyota RAV4>> Cooling and conditioning systems>> Service and repair of system of cooling>> Electric motor of the fan of a heater
       PREVENTION
Cars are equipped with the systems of safety (SRS) including safety cushions and natyazhitel of seat belts. Before work about sensors of blow, the dashboard and a steering column disconnect at first negative, and then positive the plug from the storage battery and wait for 2 minutes. It will exclude unauthorized disclosure of safety cushions and operation of natyazhitel of seat belts which can cause traumas.

Switch off ignition and disconnect a "weight" wire from the storage battery.
The fan of a heater is located in car salon over the right foot of the forward passenger.
On release cars till 2001 remove a ware box.

Fig. 4.21. Fan electric motor: And — the electric socket; In — the fan electric motor


Disconnect the electric socket from the fan engine (fig. 4.21) .
Turn out screws of fastening and take out down the fan from a casing.
If the engine of the fan is subject to replacement, remove a lock ring, remove and rearrange the fan on the new engine, fix it a lock ring.
Further installation make in sequence, return to removal.
Check operation of the electric motor of the fan.