RAV4 PAB4-Toyota Toyota
1. Car operation
2. Maintenance
3. Engines
4. Cooling and conditioning systems
   General information
   Specifications
   Service and repair of system of cooling
      Thermostat
      Radiator fan
      Radiator and broad tank
      Water pump
      The sensor of the index of temperature of cooling liquid
      Thermoswitch of the fan of a radiator
      Electric motor of the fan of a heater
      Knot of management of heating and air conditioning systems
      Heater radiator
   Check and service of central air of air
5. Fuel system and system of production of the fulfilled gases
6. Ignition system
7. The monitoring system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of a drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
Electric equipment schemes




Toyota RAV4>> Cooling and conditioning systems>> Service and repair of system of cooling>> Radiator fan
       PREVENTION
In operating time of the engine do not bring a hand too close to the fan and do not stand in the plane of rotation of the fan

Switch off ignition and disconnect a "weight" wire from the storage battery.
Disconnect the electric socket from the engine of the fan of a radiator.
On release cars till 2001 the casing of the fan of the condenser of central air of air fastens to a radiator one bolt from above and two in the basis. The casing of the main fan of a radiator fastens two bolts from above and two bolts in the basis.
On release cars since 2001 the casing of the fan of the condenser of central air of air fastens to a radiator two bolts from above and two in the basis. The casing of the main fan of a radiator fastens two bolts from above and two clamps in the basis.
Tighten the parking brake and block back wheels an emphasis.
Lift a forward part of the car and establish on support. Remove an antisplash guard of a motor compartment.
On release cars till 2001 from below the car turn out the bottom bolts of fastening of a casing of the fan.

Fig. 4.6. Arrangement of the top bolts of fastening of a casing of the fan of a radiator


From above from a motor compartment turn out the top bolts of fastening of a casing of the fan and remove its (fig. 4.6) . On release cars since 2001 release a fan casing from clamps in the basis, having pulled it up.

Fig. 4.7. A reversing of the screw of fastening of the fan to an engine shaft


Holding fan blades from a provorachivaniye, turn out the screw of fastening of the fan to a shaft of the engine and remove its (fig. 4.7) . The fan of the condenser fastens to an engine shaft three screws.

Fig. 4.8. An arrangement of screws of fastening of the engine to a fan casing


Turn out screws of fastening of the engine to a casing of the fan and remove the engine (fig. 4.8) .
Installation make in sequence, return to removal.