RAV4 PAB4-Toyota Toyota
1. Car operation
2. Maintenance
3. Engines
   Engine 3S-FE repair without its removal from the car
   Engine 1AZ-FE repair without its removal from the car
      General information
      Specifications
      Installation of the piston of the first cylinder in the top dead point (VMT)
      Cover of a head of the block of cylinders
      System of change of phases of a gazoraspredeleniye (VVT — Variable Valve Timing)
      Chain of a drive of the gas-distributing mechanism and asterisk
      Camshafts and pushers of valves
      Inlet collector
      Final collector
      Head of the block of cylinders
      Pulley/quencher of fluctuations
      Forward sealing ring of a cranked shaft
      Oil pallet
      Oil pump
      Drive flywheel / plate
      Back sealing ring of a cranked shaft
      Support of the power unit
   Diagnostics and preparation of the engine for major maintenance
4. Cooling and conditioning systems
5. Fuel system and system of production of the fulfilled gases
6. Ignition system
7. The monitoring system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of a drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
Electric equipment schemes




Toyota RAV4>> Engines>> Engine 1AZ-FE repair without its removal from the car>> Oil pallet
Removal
Removal make in the following order:
– switch off ignition and disconnect a "weight" wire from the storage battery;
– tighten the parking brake and establish an emphasis under back wheels;
– lift a forward part of the car and establish on support;
– remove an antisplash guard of a motor compartment;
– merge from the engine engine oil and turn out the oil filter;
– remove the index (щуп) oil level;

Fig. 3.89. Arrangement of bolts of fastening of the oil pallet


– turn out bolts (fig. 3.89) and remove the oil pallet. If the oil pallet sits strongly, separate it from the block of cylinders, having inserted between them a screw-driver edge, thus do not damage privalochny surfaces of the pallet and the block of cylinders.
Installation
Firm plastic or wooden scraper clear of the remains of old hermetic privalochny surfaces of the oil pallet and the block of cylinders and clear them solvent.
Check that carving openings for bolts of fastening of the oil pallet in the block of cylinders pure and have no carving damages.
Check a flange of the oil pallet, especially about openings for bolts, on existence of defects. If necessary remove available teases or notches.
Check fastening of a maslozaborny tube and lack of cracks in it. If the maslozaborny tube acted in film, clear it and establish with a new sealing ring or laying. Check on absence of pollution the mesh filter of a maslozabornik.
Put on a privalochny surface of the oil pallet a RTV hermetic layer in diameter of 5 mm.

       NOTE
It is necessary to establish the oil pallet during 5 mines after hermetic drawing.

Establish the oil pallet on the block of cylinders and fix bolts, having tightened them by hand at this stage. Consistently around, in some passes, tighten bolts the moment of 9 N • m.
Further installation is carried out to sequences, return to removal, taking into account the following.
Before filling of engine oil wait 1 h in order that hermetic managed to harden.
Establish the new oil filter and fill in in the engine engine oil.
Start up the engine and check on absence of leaks.