RAV4 PAB4-Toyota Toyota
1. Car operation
2. Maintenance
3. Engines
   Engine 3S-FE repair without its removal from the car
   Engine 1AZ-FE repair without its removal from the car
      General information
      Specifications
      Installation of the piston of the first cylinder in the top dead point (VMT)
      Cover of a head of the block of cylinders
      System of change of phases of a gazoraspredeleniye (VVT — Variable Valve Timing)
      Chain of a drive of the gas-distributing mechanism and asterisk
      Camshafts and pushers of valves
      Inlet collector
      Final collector
      Head of the block of cylinders
      Pulley/quencher of fluctuations
      Forward sealing ring of a cranked shaft
      Oil pallet
      Oil pump
      Drive flywheel / plate
      Back sealing ring of a cranked shaft
      Support of the power unit
   Diagnostics and preparation of the engine for major maintenance
4. Cooling and conditioning systems
5. Fuel system and system of production of the fulfilled gases
6. Ignition system
7. The monitoring system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of a drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
Electric equipment schemes






Toyota RAV4>> Engines>> Engine 1AZ-FE repair without its removal from the car>> Final collector
Removal
Removal of a final collector carry out on the cold engine in the following order:
– switch off ignition and disconnect a "weight" wire from the storage battery;
– tighten the parking brake and establish an emphasis under back wheels;
– lift a forward part of the car and establish on support;
– remove an antisplash guard of a motor compartment;

Fig. 3.77. Fastening of a reception exhaust pipe to a final collector: 1–bolts; 2–bolts of fastening of the lower part of a final collector; 3–oxygen sensors


– put on bolts 1,2 (fig. 3.77) and springs of fastening of a reception exhaust pipe to a final collector the means facilitating them an otvorachivaniye. After impregnation of bolts, turn out them and separate from a collector a reception exhaust pipe, thus be careful not to damage oxygen 3 sensors;
– turn out bolts of fastening of the bottom braces of a final collector;
– disconnect electric sockets from oxygen sensors;
– from a motor compartment remove the top thermofilter of a final collector. There is also bottom thermofilter which is attached from below a final collector, and it is not required to be removed;

Fig. 3.78. Arrangement of nuts of fastening of a final collector


– turn out nuts (fig. 3.78) and bolts and, having pulled from a head of the block of cylinders, remove a final collector with laying.
Installation
Installation make in the following order:
– with a scraper remove the remains of old laying and soot deposits from privalochny surfaces of a final collector and a head of the block of cylinders;
– if the new final collector is established, it is necessary to rearrange from an old collector on the new bottom thermofilter;
– establish new laying of a final collector on a head of the block of cylinders according to inscriptions available on it and signs;
– establish a final collector and fix it nuts. Tighten nuts in some passes, since the center and further on a spiral.
Further installation carry out to sequences, return to removal.
Start up the engine and check on absence of leakages of the fulfilled gases.