RAV4 PAB4-Toyota Toyota
1. Car operation
2. Maintenance
3. Engines
4. Cooling and conditioning systems
5. Fuel system and system of production of the fulfilled gases
6. Ignition system
7. The monitoring system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of a drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
   General information
   Technical characteristics
   Removal and installation of a steering wheel with a safety cushion
   Removal and installation of a steering column
   Removal and installation of tips of steering drafts
   Replacement of covers of the steering mechanism
   Removal and installation of the steering mechanism
   Removal and installation of the pump of the amplifier of a steering
   Pumping of hydraulic system of the amplifier of a steering
   Replacement of bolts of fastening of a wheel
   Wheels and tires
14. Body
15. Electric equipment
Electric equipment schemes




Toyota RAV4>> Steering and running gear>> Removal and installation of tips of steering drafts
Removal of tips of steering drafts make as follows.
Tighten the parking brake and block back wheels an emphasis.
Weaken nuts of fastening of a forward wheel. Lift a forward part of the car and establish on support. Remove a forward wheel.

Fig. 13.10. An arrangement of the nut fixed by a pin, fastenings of a pin of the spherical hinge of a tip of steering bent for to a rotary fist


Take шплинт and weaken, but do not turn out completely, a nut of fastening of a pin of the spherical hinge of a tip of steering bent for to a rotary fist (fig. 13.10) .
Passatizhami or a wrench keep from a provorachivaniye steering draft and turn out a lock-nut of a tip of steering draft on some turns, then paint note the provision of the end of a tip on steering draft.

Fig. 13.11. Stripper use for expression of a pin of the spherical hinge of a tip of steering draft from a rotary fist


Stripper squeeze out a pin of the spherical hinge of a tip of steering draft from a rotary fist (fig. 13.11) .
Turn out a nut and remove a pin of the spherical hinge of a tip of steering draft from a rotary fist.
Turn out a tip of steering draft from steering draft.
Installation of a tip of steering draft make as follows:
Screw a tip of steering draft on steering draft to a mark put before removal.
Insert a pin of the spherical hinge of a tip of steering draft into a rotary fist. Tighten a lock-nut of a tip of steering draft.
Screw a nut of fastening of a pin of the spherical hinge of a tip of steering bent for to a rotary fist, tighten it the moment of 36 N • m also establish new шплинт. If the opening in a pin for шплинта does not coincide with grooves on a nut, tighten a nut (do not turn out) before situation while grooves on a nut will not be on one line with an opening.
Establish a wheel, screw nuts, lower the car and tighten nuts of fastening of a wheel.
Check and if necessary adjust corners of installation of wheels.