Remove a spring.

Turn out bolts and remove arms of a brake tube and a cable of the parking brake from the longitudinal lever of a back suspension bracket.

Remove a nave of a back wheel together with the bearing. Remove from the longitudinal lever a protective casing of a back brake together with brake shoes and a soft wire fix on a body.

Fig. 12.24. An arrangement of the adjusting cam defining relative position of the longitudinal lever and an arm

Paint or marker note the provision of the adjusting cam defining relative position of the longitudinal lever and an arm (fig. 12.24) .

Turn out a sharnirny bolt and separate the longitudinal lever of a back suspension bracket from an arm.

Check a plug condition on lack of wear, stratification and rubber hardening. If necessary replace the plug with service stations.

Installation make in sequence, return to removal, taking into account the following.

According to earlier put labels establish an adjusting cam of the longitudinal lever defining relative situation and an arm.

Before a tightening of a sharnirny bolt of fastening of the longitudinal lever to an arm raise a jack a back part of the lever to establish the lever in situation in which it should be when the car costs on wheels.

In this position of the lever tighten all nuts and bolts of fastening of a back suspension bracket.

Check and if necessary adjust corners of installation of back wheels.