RAV4 PAB4-Toyota Toyota
1. Car operation
2. Maintenance
3. Engines
4. Cooling and conditioning systems
5. Fuel system and system of production of the fulfilled gases
6. Ignition system
7. The monitoring system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of a drive of driving wheels
11. Brake system
   General information
   Specifications
   Anti-blocking system of brakes (ABS)
   Replacement of forward brake shoes
   Replacement of a support of a forward brake
   Check and replacement of brake disks
   Replacement of back brake shoes
   Replacement of the working brake cylinder
   Replacement of the main brake cylinder
   Replacement of sealing rings of a tank of brake system
   Replacement of brake tubes and hoses
   Pumping of a hydraulic drive of brakes
   Check and replacement of the vacuum amplifier of brakes
   Adjustment of the parking brake
   Replacement of cables of the parking brake
      Replacement of a back cable
      Replacement of a forward cable
   Adjustment of provision of a pedal of a brake
   Check and replacement of the switch of a stoplight
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
Electric equipment schemes




Toyota RAV4>> Brake system>> Replacement of cables of the parking brake>> Replacement of a forward cable
The forward cable of the parking brake connects the lever of the parking brake to the jack.
Remove the central console.
Release the lever of the parking brake.

Fig. 11.42. Arrangement of a lock-nut and adjusting nut of the parking brake


Weaken a lock-nut (the top nut), thus the second key hold an adjusting nut (the bottom nut) from a provorachivaniye, then unscrew a lock-nut and an adjusting nut (see fig. 11.42 ).
Block forward wheels an emphasis.
Weaken nuts of fastening of a back wheel. Lift a back part of the car and establish it on support.
For access to the jack of the parking brake remove the thermofilters located over system of production of fulfilled gases.
Turn a cable of the parking brake on 90 ° and disconnect it from the jack.
Squeeze out condensing ring in a korytoobrazny element of the bottom of the car and extend a cable through the opened opening.
Installation make in sequence, return to removal, taking into account the following.
Grease a back part of a cable of the parking brake and connect it to the jack.
Before installation of a condensing ring put on its edges a hermetic layer that through it water did not get into salon of the car.
Adjust a cable of the parking brake.