RAV4 PAB4-Toyota Toyota
1. Car operation
2. Maintenance
3. Engines
4. Cooling and conditioning systems
5. Fuel system and system of production of the fulfilled gases
6. Ignition system
7. The monitoring system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of a drive of driving wheels
11. Brake system
   General information
   Specifications
   Anti-blocking system of brakes (ABS)
   Replacement of forward brake shoes
   Replacement of a support of a forward brake
   Check and replacement of brake disks
   Replacement of back brake shoes
   Replacement of the working brake cylinder
   Replacement of the main brake cylinder
   Replacement of sealing rings of a tank of brake system
   Replacement of brake tubes and hoses
   Pumping of a hydraulic drive of brakes
   Check and replacement of the vacuum amplifier of brakes
   Adjustment of the parking brake
   Replacement of cables of the parking brake
      Replacement of a back cable
      Replacement of a forward cable
   Adjustment of provision of a pedal of a brake
   Check and replacement of the switch of a stoplight
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
Electric equipment schemes




Toyota RAV4>> Brake system>> Replacement of cables of the parking brake>> Replacement of a back cable
The back cable of the parking brake connects brake mechanisms of back wheels to the jack.
Remove pressure in fuel system and disconnect a "weight" wire from the storage battery.
Block forward wheels an emphasis.
Weaken nuts of fastening of a back wheel. Lift a back part of the car and establish it on support.
Release the lever of the parking brake.
Remove a brake drum.
Remove brake shoes and disconnect a cable of the parking brake from the lever fixed on a back brake shoe.

Fig. 11.43. An arrangement of bolts of fastening of a cover of a cable of the parking brake to a protective casing of a back brake


Turn out two bolts of fastening of a cover of a cable of the parking brake and extend it from a protective casing of a back brake (fig. 11.43) .
Remove the fuel tank and the thermofilters located over system of production of fulfilled gases.
Turn out bolts of fastening of clips of a cable of the parking brake to the car bottom.
Disconnect a forward part of a cable of the parking brake from the jack and remove it from the car.
Installation make in sequence, return to removal, taking into account the following.
Grease a forward part of a cable of the parking brake and connect it to the jack.
Adjust a cable of the parking brake.