RAV4 PAB4-Toyota Toyota
1. Car operation
2. Maintenance
3. Engines
4. Cooling and conditioning systems
5. Fuel system and system of production of the fulfilled gases
6. Ignition system
7. The monitoring system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of a drive of driving wheels
11. Brake system
   General information
   Anti-blocking system of brakes (ABS)
   Replacement of forward brake shoes
   Replacement of a support of a forward brake
   Check and replacement of brake disks
   Replacement of back brake shoes
   Replacement of the working brake cylinder
   Replacement of the main brake cylinder
   Replacement of sealing rings of a tank of brake system
   Replacement of brake tubes and hoses
   Pumping of a hydraulic drive of brakes
   Check and replacement of the vacuum amplifier of brakes
   Adjustment of the parking brake
   Replacement of cables of the parking brake
   Adjustment of provision of a pedal of a brake
   Check and replacement of the switch of a stoplight
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
Electric equipment schemes

Toyota RAV4>> Brake system>> Replacement of the main brake cylinder>> Removal
On models till 2001 uncover the air filter and the block of safety locks and the relay on the left side of a motor compartment.

Fig. 11.35. Main brake cylinder: And – the electric socket; In – places of connection of brake tubes; With – nuts

Disconnect the electric socket from the sensor of level of brake liquid (fig. 11.35) .
Uncover a compensatory tank of brake system and, using a syringe, pump out brake liquid.
Mark the brake tubes suitable to the main brake cylinder. Put pure rags under the main brake cylinder for collecting the leaked brake liquid.
Unscrew connecting nuts of fastening of brake tubes and take tubes aside from the main brake cylinder. Close the ends of tubes suitable jams.

The brake liquid used in hydraulic system of brakes, is poisonous, therefore at hit it on skin immediately wash out the struck site a large amount of water. Brake liquid dissolves paint and plastic therefore at liquid hit on a paint and varnish covering of the car wash out it a large amount of water.

Turn out two nuts and remove the main brake cylinder from the vacuum amplifier of brakes together with laying. Check a condition of a sealing ring in an end face of the main brake cylinder and if necessary replace it.