RAV4 PAB4-Toyota Toyota
1. Car operation
2. Maintenance
3. Engines
4. Cooling and conditioning systems
5. Fuel system and system of production of the fulfilled gases
6. Ignition system
7. The monitoring system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
   General information
   Specifications
   Transmission repair
   The repair and adjusting work which is carried out on cars with a mechanical transmission
      Replacement of cables of management with a transmission
      Removal and installation of the lever of gear shifting
      Check and replacement of the switch of lamps of a backing
      Replacement of an oil radiator of a transmission
      Removal and installation of a mechanical transmission on cars with one leading bridge
      Removal and installation of a mechanical transmission on fully - driving cars
   The repair and adjusting work which is carried out on cars with an automatic transmission
10. Driveshaft and shaft of a drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
Electric equipment schemes




Toyota RAV4>> Transmission>> The repair and adjusting work which is carried out on cars with a mechanical transmission>> Replacement of cables of management with a transmission
Cables of management are not regulated by a transmission, therefore in case of damage or stretching replace them.
Removal

Fig. 9.1. Cables of management of a transmission on models till 2001: 1–handle of the lever of gear shifting; 2–the goffered protective cover; 3–central console; 4–clip; 5–clip; 6–arm; 7–block of the lever of gear shifting; 8–clip; 9–washer; 10-cable of a choice of transfers; 11-washer; 12-washer; 13-clip; 14-clip; 15-gear shifting cable; 16-holder; 17-consolidation; 18-holder of consolidation; 19-panel of a lateral upholstery; 20-panel of a lateral upholstery


In a motor compartment remove clips and washers and disconnect cables from transmission levers (fig. 9.1) .
Turn out screws, remove the holder of consolidation and consolidation of cables from a partition of a motor compartment.
In salon of the car remove the central console.
Remove clips of fastening of covers of cables to the basis of the lever of gear shifting.
Remove clips and washers and disconnect cables from the block of the lever of gear shifting.
From salon of the car turn out screws and remove the holder of consolidation of cables. Extend cables in car salon.
Installation
Installation make in sequence, return to removal.