RAV4 PAB4-Toyota Toyota
1. Car operation
2. Maintenance
3. Engines
4. Cooling and conditioning systems
5. Fuel system and system of production of the fulfilled gases
6. Ignition system
7. The monitoring system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of a drive of driving wheels
11. Brake system
12. Suspension bracket
   General information
   Specifications
   Rack of a forward suspension bracket
   Dismantling and assembly of an amortization rack
   Forward stabilizer of cross-section stability
   Bottom lever of a forward suspension bracket
   Rotary fist and nave of a forward wheel
      Removal
      Installation
   Back stabilizer of cross-section stability
   Shock-absorber of a back suspension bracket
   Levers of a back suspension bracket
   Spring of a back suspension bracket
   Nave and bearing of a back wheel
13. Steering and running gear
14. Body
15. Electric equipment
Electric equipment schemes




Toyota RAV4>> Suspension bracket>> Rotary fist and nave of a forward wheel>> Installation
If the spherical hinge acted in film from a rotary fist, establish it and fix a nut, having tightened it the moment specified in specifications, and fix the shplinty.
Moving a rotary fist in the direction to the car, establish a shaft of a drive of a wheel in a nave of a forward wheel.
Connect the lower part of a rack to a rotary fist, insert two bolts and screw on them nuts, without tightening them it is final.
Establish the bottom lever on the spherical hinge and fix it a bolt and nuts, without tightening them it is final.
Fix steering draft on a rotary fist.
Having combined earlier put labels, tighten nuts of fastening of the lower part of a rack to a rotary fist and a bolt and nuts of fastening of the spherical hinge to the bottom lever.
Establish a brake disk and a support.
Screw a nut of fastening of a shaft of a drive of a wheel to a nave. On models since 2001 use a new nut. Previously tighten a nut.
Establish a wheel and fix it nuts. Lower the car.
On the car standing on wheels, finally tighten a nut of fastening of a shaft to a nave the moment of 216 N • m. On models till 2001 screw a lock-nut and shplinty fix it from an otvorachivaniye. On models since 2001 a hammer and a punch hammer a nut fillet into a groove of a power shaft.
Check and if necessary adjust corners of installation of forward wheels.