RAV4 PAB4-Toyota Toyota
1. Car operation
2. Maintenance
3. Engines
4. Cooling and conditioning systems
5. Fuel system and system of production of the fulfilled gases
6. Ignition system
7. The monitoring system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of a drive of driving wheels
11. Brake system
12. Suspension bracket
   General information
   Specifications
   Rack of a forward suspension bracket
   Dismantling and assembly of an amortization rack
   Forward stabilizer of cross-section stability
   Bottom lever of a forward suspension bracket
      Removal
      Installation
      Replacement of the spherical hinge of the bottom lever of a forward suspension bracket
   Rotary fist and nave of a forward wheel
   Back stabilizer of cross-section stability
   Shock-absorber of a back suspension bracket
   Levers of a back suspension bracket
   Spring of a back suspension bracket
   Nave and bearing of a back wheel
13. Steering and running gear
14. Body
15. Electric equipment
Electric equipment schemes




Toyota RAV4>> Suspension bracket>> Bottom lever of a forward suspension bracket>> Removal
Tighten the parking brake and block back wheels an emphasis.
Weaken nuts of fastening of a forward wheel. Lift a forward part of the car and establish it on support. Remove a forward wheel.
On models till 2001 turn out a nut and disconnect draft of the stabilizer of cross-section stability from the bottom lever of a forward suspension bracket.

Fig. 12.11. An arrangement of a bolt and nuts of fastening of the spherical hinge to the bottom lever of a forward suspension bracket


Turn out a bolt and two nuts of fastening of the spherical hinge to the bottom lever of a forward suspension bracket (fig. 12.11) . Mount separate the spherical hinge from the bottom lever of a forward suspension bracket
Turn out a sharnirny bolt of fastening of the forward party of the bottom lever. On models till 2001 with an automatic transmission at removal of the left lever turn out bolts, lower the bottom cross-section beam and turn out a sharnirny bolt of fastening of the forward party of the bottom lever.

Fig. 12.12. An arrangement of bolts and a nut of fastening of an arm with the basic plug of the back party of the bottom lever on models till 2001


On models till 2001 turn out two bolts and a nut and remove an arm with the basic plug of fastening of the back party of the bottom lever (fig. 12.12) .

Fig. 12.13. An arrangement of a bolt of fastening of the basic plug of the back party of the bottom lever on models since 2001


On models since 2001 turn out a bolt of fastening of the basic plug of the back party of the bottom lever (fig. 12.13) .
Remove the bottom lever.
Examine the lever on absence of deformations, traces of corrosion and wear of basic plugs. It is forbidden to prepare the deformed lever.