RAV4 PAB4-Toyota Toyota
1. Car operation
2. Maintenance
3. Engines
4. Cooling and conditioning systems
5. Fuel system and system of production of the fulfilled gases
6. Ignition system
7. The monitoring system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of a drive of driving wheels
11. Brake system
12. Suspension bracket
   General information
   Specifications
   Rack of a forward suspension bracket
      Removal
      Check
      Installation
   Dismantling and assembly of an amortization rack
   Forward stabilizer of cross-section stability
   Bottom lever of a forward suspension bracket
   Rotary fist and nave of a forward wheel
   Back stabilizer of cross-section stability
   Shock-absorber of a back suspension bracket
   Levers of a back suspension bracket
   Spring of a back suspension bracket
   Nave and bearing of a back wheel
13. Steering and running gear
14. Body
15. Electric equipment
Electric equipment schemes






Toyota RAV4>> Suspension bracket>> Rack of a forward suspension bracket>> Removal
Tighten the parking brake and block back wheels an emphasis.
Weaken nuts of fastening of a forward wheel. Lift a forward part of the car and establish it on support. Remove a forward wheel.
Turn out a bolt of fastening of an arm of a brake hose to a rack of a forward suspension bracket. In the presence of ABS turn out bolts of fastening of clips of wires and separate a plait of wires of the sensor from a rack.
On models since 2001 disconnect draft of the stabilizer of cross-section stability from an arm on a rack.
Note the mutual provision of the lower part of a rack and a rotary fist that at installation not to break wheel disorder. Also note the provision of heads of bolts because on a part of cars special adjusting bolts were established.

Fig. 12.1. Otvorachivaniye of nuts of fastening of the lower part of a rack of a forward suspension bracket to a rotary fist


Unscrew two nuts and a hammer and a drift beat out two bolts of fastening of the lower part of a rack to a rotary fist (fig. 12.1) .
Separate the lower part of a rack from a rotary fist.

       PREVENTION
Be careful not to damage the internal CV JOINT of a power shaft. Also prevent falling of a rotary fist outside of the car, it can lead to stretching or a rupture of a brake hose.


Fig. 12.2. An arrangement of nuts of fastening of the top part of a rack of a forward suspension bracket to a car body


Supporting a rack from below, turn out three nuts of fastening of the top part of a rack to a car body (fig. 12.2) . Take a rack from under a car wing.