RAV4 PAB4-Toyota Toyota
1. Car operation
2. Maintenance
3. Engines
4. Cooling and conditioning systems
5. Fuel system and system of production of the fulfilled gases
6. Ignition system
7. The monitoring system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of a drive of driving wheels
11. Brake system
   General information
   Specifications
   Anti-blocking system of brakes (ABS)
   Replacement of forward brake shoes
   Replacement of a support of a forward brake
      Removal
      Installation
   Check and replacement of brake disks
   Replacement of back brake shoes
   Replacement of the working brake cylinder
   Replacement of the main brake cylinder
   Replacement of sealing rings of a tank of brake system
   Replacement of brake tubes and hoses
   Pumping of a hydraulic drive of brakes
   Check and replacement of the vacuum amplifier of brakes
   Adjustment of the parking brake
   Replacement of cables of the parking brake
   Adjustment of provision of a pedal of a brake
   Check and replacement of the switch of a stoplight
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
Electric equipment schemes




Toyota RAV4>> Brake system>> Replacement of a support of a forward brake>> Removal
Tighten the parking brake and block back wheels an emphasis.
Weaken nuts of fastening of a forward wheel. Lift a forward part of the car and establish it on support. Remove a forward wheel.

Fig. 11.14. Reversing of the bottom bolt of fastening of a support of a forward brake: And – the bottom bolt; In – the top bolt; With – a hollow bolt of fastening of a brake hose


Fig. 11.19. Closing of an opening of a brake hose by a piece of a rubber hose


If the support acts in film for access to other components, do not disconnect from it a brake hose. Otherwise turn out a hollow bolt of fastening of a brake hose to a support (to C on fig. 11.14 ). For prevention of an effluence of brake liquid close an opening of a brake hose a stopper or a piece of a rubber hose of suitable diameter (fig. 11.19) .
Turn out the top and bottom bolts of fastening of the support, thus the second key hold directing fingers from a provorachivaniye (see fig. 11.14 ). If the support acts in film for access to other components, a soft wire tie up it to a forward rack.