Grease working edges of a sealing cuff of a transmission. Insert a forward part of the driveshaft into a transmission and screw, but do not tighten, bolts of fastening of an arm of the basic bearing of the driveshaft to the car bottom.

Connect the back universal hinge of the driveshaft to a flange of the main reverse gear, having combined the labels put before removal. Fix it nuts and bolts and tighten them the moment of 74 N • m.

Fig. 10.12. Distance between a cover of the hinge and a ledge on a back part of the driveshaft

Fig. 10.13. Distance between a back part of the basic bearing and a back part of a rubber support

Adjust the provision of an arm of the basic bearing of the driveshaft so that the distance between a cover of the hinge and a ledge on a back part of the driveshaft was in limits of 65,5-70,5 mm, and the distance between a back part of the basic bearing and a back part of a rubber support should be in limits of 11,5-13,5 mm (fig. 10.12, 10.13) . Tighten bolts of fastening of an arm of the basic bearing of the driveshaft the moment of 37 N • m.