The back stabilizer of cross-section stability is established on models since 2001

Block forward wheels an emphasis. Lift a back part of the car and establish it on support.

Fig. 12.16. Arrangement of a nut of fastening of draft of the stabilizer of cross-section stability to the stabilizer

Unscrew nuts of fastening of drafts of the stabilizer of cross-section stability (fig. 12.16) . At an otvorachivaniye of nuts of fastening of spherical hinges of draft of the stabilizer a six-sided key hold from a provorachivaniye a pin of the spherical hinge.

Fig. 12.17. An arrangement of nuts of fastening of the clips, fixing the stabilizer of cross-section stability to a car body

Turn out bolts of fastening of clips with the plugs, fixing the stabilizer of cross-section stability to a car body (fig. 12.17) .

Remove the stabilizer of cross-section stability from the car.

Remove from the stabilizer basic plugs and check their condition.

Check a condition of spherical hinges of drafts of the stabilizer. For this purpose remove them from the car and fix in a vice (fig. 10). Reject against the stop in one and other party a pin of the spherical hinge, then screw a nut on a pin. A Dinamometrichesky key turn a pin of the spherical hinge (one turn for 2–4 c), and on the fifth turn measure a torque of a provorachivaniye which m should be not less than 0,04 N •. Otherwise replace draft of the stabilizer.

Wire brush clear stabilizer zones on which basic plugs are established.