Fill in engine oil and cooling liquid.

Turn out from the engine of a spark plug and disconnect the electric socket of giving of tension to the fuel pump.

Starter turn a cranked shaft of the engine until the control lamp of pressure of oil will go out.

Screw spark plugs and connect the electric socket of giving of tension to the fuel pump.

Start up the engine. Probably, start-up of the engine will be more long as time for pressure creation in fuel system is required.

Warm up the engine to working temperature. In process of warming up of the engine watch closely possible emergence of leakages of oil, fuel or cooling liquid. Emergence of unusual smells and a smoke from the details which are exposed to influence of high temperature, because of burning out of the remains of oil is allowed.

Stop the engine and check levels of engine oil and cooling liquid and if necessary add.

If new pistons, piston rings, radical and shatunny loose leaves were established, the engine should pass a running in throughout the first 800 km of run. In a running in operation with completely open butterfly valve or with too small speed on any transfer is not allowed.

After a running in replace engine oil and the oil filter.

After run of 3000 km again replace engine oil and the oil filter.