RAV4 PAB4-Toyota Toyota
1. Car operation
2. Maintenance
3. Engines
4. Cooling and conditioning systems
5. Fuel system and system of production of the fulfilled gases
6. Ignition system
7. The monitoring system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of a drive of driving wheels
11. Brake system
   General information
   Specifications
   Anti-blocking system of brakes (ABS)
   Replacement of forward brake shoes
   Replacement of a support of a forward brake
   Check and replacement of brake disks
   Replacement of back brake shoes
   Replacement of the working brake cylinder
   Replacement of the main brake cylinder
   Replacement of sealing rings of a tank of brake system
   Replacement of brake tubes and hoses
   Pumping of a hydraulic drive of brakes
   Check and replacement of the vacuum amplifier of brakes
   Adjustment of the parking brake
   Replacement of cables of the parking brake
   Adjustment of provision of a pedal of a brake
      Height of installation of a pedal
      Free wheeling of a pedal of a brake
      Stock of a course of a pedal of a brake
   Check and replacement of the switch of a stoplight
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
Electric equipment schemes






Toyota RAV4>> Brake system>> Adjustment of provision of a pedal of a brake>> Height of installation of a pedal

Fig. 11.44. Height of installation of a pedal of a brake: 1–pusher; 2–stoplight switch; X – height of installation of a pedal of a brake


Measure height of installation of a pedal of a brake which should be in the limits given in specifications and on fig. 11.44 . If necessary adjust height of installation of a pedal of a brake as follows.
Remove the bottom casing of a steering column.
Disconnect the electric socket from the stoplight switch.
Weaken a lock-nut of the switch of a stoplight and turn out it.
Weaken a pusher lock-nut.
Adjust height of installation of a pedal of a brake, rotating a pusher in one or other party.
Tighten a pusher lock-nut.
Establish the switch of a stoplight and wrap it till a contact of the case of the switch with the limiter of a course of a pedal of a brake.
Turn out the stoplight switch on one turn.

Fig. 11.45. Gap measurement between a carving part of the case of the switch and the limiter of a course of a pedal of a brake: And = 0,5–2,4 mm


Measure distance between a carving part of the case of the switch and the limiter of a course of a pedal of a brake which should be in limits of 0,5-2,4 mm (fig. 11.45) .
Tighten a lock-nut of the switch of a stoplight.
Connect the electric socket to the stoplight switch.
Check that stoplights light up by pressing of a pedal of a brake and die away at its otpuskaniye.