RAV4 PAB4-Toyota Toyota
1. Car operation
2. Maintenance
3. Engines
4. Cooling and conditioning systems
   General information
   Specifications
   Service and repair of system of cooling
      Thermostat
      Radiator fan
      Radiator and broad tank
      Water pump
      The sensor of the index of temperature of cooling liquid
      Thermoswitch of the fan of a radiator
      Electric motor of the fan of a heater
      Knot of management of heating and air conditioning systems
      Heater radiator
   Check and service of central air of air
5. Fuel system and system of production of the fulfilled gases
6. Ignition system
7. The monitoring system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of a drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
Electric equipment schemes






Toyota RAV4>> Cooling and conditioning systems>> Service and repair of system of cooling>> Knot of management of heating and air conditioning systems
Replacement of knot of management
Prevention

       PREVENTION
Cars are equipped with the systems of safety (SRS) including safety cushions and natyazhitel of seat belts. Before work about sensors of blow, the dashboard and a steering column disconnect at first negative, and then positive the plug from the storage battery and wait for 2 minutes. It will exclude unauthorized disclosure of safety cushions and operation of natyazhitel of seat belts which can cause traumas.

Switch off ignition and disconnect a "weight" wire from the storage battery.
Remove the central overlay of the dashboard.
On release cars till 2001 remove a ware box and the bottom central overlay of the dashboard. Remove handles of management and the control panel heating and conditioning.
On release cars since 2001 remove a radio receiver and the bottom left panel from the central console.
Disconnect management cables from levers and a cover of cables from clips on knot of management of heating and air central air.

Fig. 4.22. An arrangement of screws of fastening of knot of management of heating and conditioning on cars till 2001


Fig. 4.23. An arrangement of screws and clamps (in the bottom of) fastening of knot of management by heating and conditioning on cars since 2001


Turn out the screws located on the forward party of knot of management (fig. 4.22, 4.23) .
Take from the dashboard knot of management of heating and air central air together with the wires connected to it and cables.
Installation make in sequence, return to removal.
Get the engine and check functioning of systems of heating and air conditioning.
Adjustment of cables
managements on cars
release till 2001
To adjust a cable of management of zaslonky supply of air in car salon, establish a control lever in the situation RECIRC, connect a cable and fix a cable cover a clip.
To adjust a cable of management of the air temperature submitted to salon of the car, establish a control lever in the situation COOL, connect a cable and fix a cable cover a clip.
To adjust a cable of management of distribution of streams of air, establish a control lever in the situation DEF, connect a cable and fix a cable cover a clip.
Adjustment of cables
managements on cars
release since 2001
To adjust a cable of management of the air temperature submitted to salon of the car, establish a control lever in the situation MAX COOL, connect a cable and fix a cable cover a clip.
To adjust a cable of management of distribution of streams of air, move a control lever against the stop in the direction to a back part of the car. Connect to the lever a cable and fix a cable cover a clip.